Your SOLO chainsaw - Throttle control lock and throttle control, - Chain lubrication adjusting screw,
- Grip heating (models 665H / 675H / 681H only)
ENGLISH 16
E
N
G
3.5 Throttle control lock and throttle control
To release the throttle control (11):
• Hold the rear handle with your right hand - the throttle
control lock (10) is activated by the flat of your hand
! The throttle control is released.
3.6 Chain lubrication adjusting screw
Your new SOLO chainsaw is equipped with an automatic chain lubrication system which
automatically stops the delivery of oil when the chainsaw is idling (Eco-Matic). When the
throttle is operated and the saw chain is driven again the chain lubrication automatically
restarts.
To adjust the delivery volume, the regulating screw (29)
underneath the power saw can be adjusted in a range of approx.
70°. In the delivered condition it is adjusted to its centre position.
As a rule of thumb, it is suggested to slightly increase the
delivery volume when sawing particularly dry wood and/or when
using a greater bar length. The oil supply can be slightly reduced
when making easy cuts or when cutting wet, soft wood with rather
shorter bar lengths.
3.7 Grip heating (models 665H / 675H / 681H only)
On the 665H, 675H and 681H models, the electric grip
heating can be switched on via the switch (9).
Heat builds up slowly both via the front handle for the left hand
and via the rear handle for the right hand - in similar fashion to
the rear window heating system on a car.
Particularly in applications in a damp environment, under cold
temperatures or high humidity the grip heating helps to prevent
working gloves from becoming excessively soaked and stimulates
circulation to the hands.
To Next Page
Loading...
