09
Recirculating Installation
• Before beginning the installation of your rangehood,
consider your ducting method.We recommend ducting
your rangehood wherever possible to ensure maximum
performance, however this rangehood can be operated
in recirculating mode. In order to operate in recirculating
mode, you will need to purchase the relevant Carbon
Filter accessory which is available for purchase via our
After Sales Service Team.
• If you do not have an outlet to the outside, an exhaust
pipe is not required. The rest of the installation method
is the same as Ducted Installation.
• If you opt for recirculating installation, it is necessary to
install the check-valve on the vent hole, and the venting
knob (shown below) is set to Circulating-Air Mode.
Check-Valve Installation
• Hold onto check valve with your hands, align the box
gap, place the check valve into the gap, and then rotate
until the three groves of the check valve are secured.
Circulating-Air Mode
Turn the venting knob here to enable recirculation.
Extraction-Air Mode
Turn the venting knob here to enable venting outside.
To Next Page
Loading...
