12
SETTING THE ANALOG OUTLET TIMER
The use of an outlet timer is essential for maintaining proper growth of your
plants. Never leave your light on for 24 hours, your plants need to sleep!
Setting the timer:
1. Locate the pins around the outer edge of the timer’s dial. These pins
represent 30 minutes.
2. Determine the light cycle that best fits your plant. This can be done
by asking your nursery, finding the information online, or by
finding out where the plant is native and mimicking the light cycle
of that location. If you cannot determine the light cycle, we
recommend either mimicking the current sunrise/sunset of your
location or keeping a 16 hour on/8 hour off cycle. Adjust as needed.
3. Pull up on the pins to turn the light off, push down to turn the light
on. We recommended having the light on during the times you are
awake. This will help prevent night interruption.
4. Rotate the timer’s dial clockwise until the pointer on the face of the
dial points to the current time.
5. Set the master switch on the timer to the “timer on” position.
6. Plug the Highland into the outlet on the side of the timer. Plug the
timer into the wall outlet. To override the timer and turn on the
Highland, set the master switch to “outlet on” position.
To Next Page
Loading...