3
IMPORTANT SAFETY INSTRUCTIONS
1. Read all safety and operating instructions before using this product.
2. Not for use with dimmers of any kind.
3. TURN OFF ELECTRICITY at the main fuse box before installing, adding to
or changing the configuration of the fixture.
4. For indoor use only.
5. Do not install this fixture in a damp or wet location.
6. Install the fixture in a manner consistent with its intended use and in
compliance with the National Electrical Code and with other local
electrical codes.
7. Track rails must maintain polarity.
8. Do not cut the track rails.
9. Use this product only as described in this manual. Any other use is not
recommended by the manufacturer and may cause fire, electrical shock or
injury, and may void the warranty.
10. Avoid eye contact directly with the LED light.
11. Always turn off or unplug the unit before cleaning to reduce risk of
electrical shock. Do not stick anything inside of the rails.
12. Only use a dry or lightly damp cloth to clean the Highland, do not use a
wet cloth or spray anything into or on the unit.
13. The use of attachments not recommended or sold by the manufacturer
may cause injury.
14. Do not operate the product in the presence of explosive and/or flammable
fumes.
15. (For corded systems) If the plug loosely fits in the outlet, discontinue use
with that outlet. A loose-fitting plug may cause the plug or outlet to
overheat. Have a qualified electrician replace the outlet.
16. If you have pets, make sure the wires are out of reach and you check that
your plants are animal friendly.
To Next Page
Loading...