How to troubleshoot a Solter Core 140i Welding System that does not start?
If your Solter Welding System doesn't start and the green LED is off, first ensure the electric supply socket has power. Then, turn off the equipment or disconnect it for 1 minute and try starting it again. It could be a defective switch. If the problem persists, it may be a defective electronic circuit, and you should contact your distributor.
What to do if my Solter Core 140i Welding System doesn't work and the amber LED is on?
If the amber LED light is on and the Solter welding machine doesn't work, it could be overheated and in the cooling phase, so wait until it cools down. It may also be due to inadequate voltage, possibly from using an inappropriate extension cord.
Why is the arc unstable on my Solter Core 140i?
If you're experiencing an unstable arc with your Solter Welding System, the workpiece might be rusty or poorly prepared for welding. You should also check the contact for the earth terminal.
What causes poor penetration in a Solter Welding System weld?
Poor penetration in your Solter Welding System can occur due to low welding intensity, welding too fast or reverse polarity.
What causes spattering when using a Solter Core 140i?
Spattering with your Solter Welding System can happen due to excess welding current.
Why are there pores in the weld of my Solter Core 140i?
Pores in the weld of your Solter Welding System can be caused by a moist electrode or cold parts during welding.
General| Brand | Solter |
|---|---|
| Model | Core 140i |
| Category | Welding System |
| Language | English |
To Next Page
