Solution 3 Series - Quick Start Guide

Stereo amplifier 311
User manual
Page 3
Table of contents
1 Highlights ....................................................................................... 4
2 Safety advice: .............................................................................. 5
3 Scope of delivery .............................................................................. 6
4 Rear side ........................................................................................ 6
5 Front side........................................................................................ 7
6 Remote control ................................................................................ 8
7 Program-Mode ................................................................................. 9
8 Trouble shooting ............................................................................ 11
9 Service ......................................................................................... 11
10 Safety functions ............................................................................. 12
11 Warranty ....................................................................................... 12
12 Specification ................................................................................. 13
13 Dimensions ................................................................................... 14
Quick start
Unpacking
ð
Unpack the 311
stereo
amplifier
ð Keep the packing for future transportations
Treat the top class surface with care
Positioning
ð
Position the 3
11 stereo
amplifier on a stable base.
Cooling air must be able to escape unrestrictedly.
Cabling
ð
Disconnect all components of your system from the
mains
ð Connect the 311 with your loudspeakers
ð Connect the 311 with your preamplifier
ð Reconnect all components of your system with the mains
While changing cables the 311
must remain disconnect
from the mains.
Programming
ð
Default values for all functio
ns are programmed.
ð No additional programming is required for the start-up.
Switch-on
ð
Switch
-
on your preamplifier
ð Select a moderate volume level
ð Switch-on your source components
ð Switch-on your 311 stereo amplifier
Check the cabling before switch-on