28
SHUTDOWN PROCEDURES
The following shutdown procedures must be followed prior to performing necessary cleaning
and maintenance duties.
1. Allow the Pulper to operate approximately five minutes after the last waste has been fed.
2. Depress black “TIMED STOP” pushbutton once to engage spray rinse system, system will
then time out on its own. The Pulper will stop when the shutdown timer has timed out.
3. Press “DRAIN EMPTY” pushbutton on panel door to drain the pulping system. This
pushbutton will DRAIN all water in the system.
4. Turn power off to perform any cleaning or maintenance.
5. Refer to the applicable Pulper and Hydra-Extractor
®
maintenance sections of this manual for
daily, weekly and long-term shutdown cleaning procedures and maintenance instructions.
To Next Page
Loading...