48
DISPLAY MODULE LOCATED IN CONTROL PANEL
SET POINTS FOR CLOSED COUPLED UNITS
D0 – Pulper water initial fill duration (seconds). 0-1,200 second span
D1 – Pulper makeup water during operation (seconds). 0-30 second span.
D2 – Timed Stop duration (seconds). 0-1,200 second span
D3 – Return Pump Start Delay (seconds) IF APPLICABLE. 0-20 second span
D4 – Auxiliary Fill Duration (Optional with auxiliary pump) IF APPLICABLE.
D5 – Pulper Hours of Operation.
D6 – Pulper Minutes of Operation.
D7 – Pulper seconds of Operation (displayed in 1/10ths of seconds).
To Next Page
Loading...