51
9. To change make-up water duration time (D1) press OK once, then “+” or “-“ to change value
and then press “OK” (enter value found in table above). To go toD3 (D13 for remote
machines) press the “+” button once, if D4 (D14 for remote machines), press the “+” button
twice.
10. To change the Timed Stop Duration (D2) press OK once, then + + (enter value found in table
above).
11. To verify all changes, drain the pulper and follow restart procedure. Verify how many
seconds the freshwater solenoid remains on while the pulper is in operation.
To Next Page
Loading...