To Next PageTo Next PageWhat to do if my SOMFY Dexxo Pro 800 RTS Garage Door Opener shows error CC?
If the SOMFY Garage Door Opener displays error code CC, you can confirm or modify the current “PA” value, or deactivate the “Maintenance required indicator” function.
How to stop siren on SOMFY Garage Door Opener (H1 error)?
If the SOMFY Garage Door Opener siren is sounding (H1), press a button on the memorised remote control to stop the siren. Then, start a complete opening and closing cycle.
How to stop siren on SOMFY Dexxo Pro 800 RTS (H2 error)?
If the SOMFY Garage Door Opener siren is sounding (H2), press a button on the memorised remote control to stop the siren. Then, start a complete opening and closing cycle.
What to do if SOMFY Dexxo Pro 800 RTS Garage Door Opener shows error E2?
If your SOMFY Garage Door Opener displays error E2, check for any obstacles triggering the cell or sensor bar detection. Also, verify that “P2” is set up correctly based on the devices connected to the safety input and check the safety device wiring. If you're using photoelectric cells, make sure they are properly aligned.
What to do if SOMFY Dexxo Pro 800 RTS shows error E4?
If your SOMFY Garage Door Opener displays error E4, verify that “P2” is set up correctly depending on the devices connected to the safety input and check the safety device wiring. If you're using photoelectric cells, ensure they are properly aligned.
What to do if SOMFY Dexxo Pro 800 RTS Garage Door Opener shows error Eb Ec?
If your SOMFY Garage Door Opener displays error codes Eb or Ec, cut the power supply (both mains and battery back-up), wait a few minutes, and then reconnect the power supply. After that, perform a learning cycle. If the fault persists, contact Somfy Technical Support.
General| Brand | SOMFY |
|---|---|
| Model | Dexxo Pro 800 RTS |
| Category | Garage Door Opener |
| Language | English |
