8
GB
TROUBLESHOOTING
Clearing remote controls
Press the “PROG” button until the light blinks (7 s).
This clears all of the remote controls memorised.
Resetting all settings
Press the “SET” button until the light goes out (7 s).
This clears all previously stored settings and returns them to their default values.
Fig. 40
Fig. 39
CLEARING REMOTE CONTROLS AND ALL SETTINGS
Operating codes displayed
CCooddee
Description Comments
C1 Waiting for a command
C2 Door opening
C3 Waiting for the door to close
C4 Door closing
C5 Obstacle detection Displayed during obstacle detection then for 30 s.
C6 Safety input active
Displayed after a movement request or during movement, when the safety input is active.
This display is maintained as long as the safety input is active.
C9 Pedestrian door safety contact active
Displayed after a movement request or during movement, when the pedestrian door contact is open.
The display is maintained as long as the pedestrian door contact remains open.
Ca Safety mechanism self test Displayed during safety mechanism self tests.
Cb Permanent hardwired control
Indicates that the permanent hardwired control input is activated (contact closed). Commands from radio remote
control units are inhibited.
Cd
Working from back-up battery
Waiting for a command
SPECIAL OPERATION
Refer to the User’s Manual, page 5.
Programming example:
setting the ”P7” closure approach speed (Fig. 34).
Setting up a long soft stop function zone “
P7” = 2.
Special case: adjusting the position of the door for partial opening (Fig. 35).
Select setting “P6” and validate by pressing “OK”.
Move the door to the desired partially open position:
. Pressing and holding the “
-” button will close the door.
. Pressing and holding the “
+” button will open the door.
. Validate by pressing “
OK”.
Forced mode (Fig. 36).
This function is used to move the door to a specific position:
. Pressing and holding the “
-” button will close the door.
. Pressing and holding the “
+” button will open the door.
Memorising the remote control for controlling remote lighting (Fig. 37).
Memorising a Telis or similar type remote control (Fig. 38).
To Next Page
Loading...
