VENT PLUG
VENT PLUG
Ø48 (1.89”)
Ø60 (2.36”)
49 (1.92”)
171 (6.73”)
9 (.35”)
3 x M8 / Ø60
3 x M6x18 / Ø48
204 (8.03”)
61 (2.4”)
277 (10.9”)
19 (.74”)
- Motor Type : Asynchronous, single-phase,
totally enclosed (IP33 / IP44).
- Built-in safety power switch is off when over-
ride is engaged
- Motor with built-in start and run capacitor
- Built-in brake.
- Pull-on manual override engages when pul-
ling crank handle.
- Manual override ratio : 1/26
- 152mm (6) power cable
TYPE
PH 50/12 12 RPM
230V - 50Hz
1,8A - 390W
38 TURNS
38 TURNS 12 5,5
12 5,5 586 265
353 160
440 200
265 120
352 160
210 95
120V - 60Hz
2,7A - 320W
14 RPM
440 50
265 30PH 30/14*
TORQUE
IN LBS. Nm
SPEED ELECTRICAL
RATING
LIMIT SWITCH
CAPACITY
WEIGHT
LB KG
OD = 1,5''
LB KG
OD = 2''
LB KG
OD = 2,5''
LB KG
Cat. n°.
9129576
9129687
9129643
9129644
9129686
Description
Adaptor Sleeve 19mm square to 13mm square.
Compatible with ref. - 9129644 and 9129643.
Material - cast aluminium.
Phoenix 19mm Square Drive Adaptor.
fits direcctly into motor shaft.
Tubular Dimensions - 36.5mm O.D. x 28.25 I.D.
Material - zinc plated steel.
Drive End Cap with Ø12 / 13mm square shaft.
for 2” x 1.86 : I.D. tube.
Same as above for 2.5” x 2.37” I.D. Tube.
Material - End cap: cast aluminium. Shaft: zinc plated steel.
Heavy duty angle plate bracket.
with 2 M6 screws.
Material - steel with durable paint finish.
* UR and CSA certified
PRODUCT FEATURES & DIMENSIONS (dimensions in parentheses are in inches)
1
MOTOR SPECIFICATION
2
ACCESSORIES
3
GB
SOMFY SAS, 50 avenue du Nouveau Monde, 74300 Cluses - FRANCE - (33) 4 50 96 70 00 - capital 20.000.000 € - RCS Bonneville 303.970.230
5054358A
PHOENIX MOTOR
Read carefully these instructions
before any use.
1 /2
- MOUNT MOTOR VERTICALLY ONLY.
- VENT PLUGS MUST BE REMOVED IN WET ENVIRONMENT.
To Next Page
Need help?
General
