SOMFY J4 io Protect User Manual

O
RIGINAL INSTRUCTIONS
Complete instruction guide available online on www.somfy.info
L
N
2
10 min
0.5 s
PROG.
N
L
1
2
3
4
OFF
1 4
2
3
N
L
230 V 50 Hz
Blue
Brown
Green - Yellow
PREPROGRAMMING A CONTROL POINT
PAIRING
From the Application
“Help me by Somfy”
scan the QR code here
to find complete
setting instructions.
“Help me by Somfy”
available on stores
Short installation guide
UP DOWN
the drive is supplied in lower end limit position. The mushroom can therefore be used to set the upper end limit position.
A minimum of 3 rotations of the drive shaft is required between the lower end limit and the upper end limit.
Factory setting :
You can go
to the step
Control point is temporary
programmed for 10 minutes.
DIRECTION OF ROTATION
END LIMITS SETTING
Control point is completely
programmed.
SETTING THE UPPER END LIMIT
Ensure that the EVB is at least 15 cm below the new desired upper end limit.
Other setting like Tilting travel, Obstacle detection, Automatic adjustment and more are available from the “Help me by Somfy” application
USE
This drive does not require any maintenance operation
UP MYSTOPDOWN
5156397A
EN J4 io Protect

SOMFY J4 io Protect Specifications

General

Brand	SOMFY
Model	J4 io Protect
Category	Engine
Language	English

Summary

Control Point Programming and Pairing

Preprogramming a Control Point

Guides on the initial programming of a control point for the drive.

Direction of Rotation

Instructions for setting the direction of rotation for the drive.

Pairing a Control Point

Details on how to completely program and pair a control point.

Setting Drive End Limits

Setting the Upper End Limit

Provides steps to set the upper end limit position for the drive.

Drive Usage

Drive Resetting and General Instructions

Drive Resetting

Explains how to reset all programmed control points and settings.

Field of Application

Describes the intended uses and limitations of the J4 io Protect drive.

Safety Instructions for Wiring

Crucial safety guidelines related to the electrical wiring of the drive.

Specific Operating Instructions

Details specific operational constraints and recommendations.

Technical Specifications

Covers radio frequency bands, maximum power, and power supply details.