SOMMER SPA - SPA System Parameterization; Connection Establishment via Terminal

User Manual SPA Snow Pack Analyser
- 11 -
4. Parameterization
4.1. Connection establishment via terminal
4.1.1. Local communication
The parameterization of the IASP can be performed by directly connecting the serial interface with a PC or
laptop. Any communication program can be used.
Until Windows XP the terminal program HyperTerminal was included in the Windows operating systems under Start


 Programs 

 Accessories 

 Communications 

 HyperTerminal.
The connection cable is a serial data cable with a 1:1 connection (not crossed).
Fig. 14: Connection of the IASP via serial interface
To communicate with the sensor in delivery state the following settings are required:
Baud rate: 9600
Data bits: 8
Parity: none
Stop bits: 1
Flow control: none
Tab. 2: Parameter settings for serial connection
4.1.2. Connection affirmation
If a connection is established and the sensor is switched on, a connection affirmation is sent.
IA-SPA
(c)2006-2012 Sommer GmbH&CoKG
Software version : wdV3.33r01