Sleep Apnea Therapy User Manual Page 35
Using the CPAP
Note In the event of power loss during ramp, the CPAP will resume at the full prescribed pressure as soon as
power is restored.
Ending therapy
To end the delivery of CPAP therapy while the blower is on, press the Power button to deactivate the blower.
If the blower is off while the power is applied, the device is in standby mode. It is recommended that you initiate
drying mode function to clean the Transcend interior after completing each therapy session.
Drying mode
When your therapy session is complete, put the CPAP device in drying mode by holding the Ramp button down
and pressing the Power button.
The blower then operates at a relatively low speed without pressure regulation. This allows the air path through
the output hose and the interface to be flushed with fresh air and removes traces of moisture from the CPAP
interior. After 30 minutes, the device automatically enters standby mode.
To Next Page
Loading...
