SMA 210/410 Deployment Guide
Additional Configuration
5
18
Additional Configuration
This section describes some additional configuration settings for your SMA 210/410, depending on the
deployment scenario you selected.
Topics:
• Configuring the X0 IP Address
• Adding a NetExtender Client Route
• Setting Your NetExtender Address Range
• Adding a New SMA Custom Zone
Configuring the X0 IP Address
When deploying the SMA in any of the scenarios mentioned in Selecting a Deployment Scenario on page 3, you
need to reset the IP address of the X0 interface on the SMA to an address within the range of the new or existing
DMZ or the existing LAN subnet.
To configure the X0 IP address:
1 Connect your computer to X0 and log into the SMA appliance by navigating to
https://192.168.200.1 on your Web browser.
2 Navigate to the Network > Interfaces page.
3 In the Interfaces table, click the Configure icon for the X0 interface.
4 In the Interface Settings dialog box, set the IP Address to an unused address within your DMZ or LAN
subnet.
5 For the Subnet Mask, enter the value that matches your DMZ or LAN subnet mask, such as
255.255.255.0.
6 Click Accept. A warning displays that you are changing the X0 IP Address. Click OK to acknowledge.
7 Reset the management computer to have a static IP address in the range you just set for the X0 interface.
For example, if you set X0 to 10.1.1.10, you could set your computer to 10.1.1.20.
8 Log into the SMA management interface again, using the IP address you just configured for the X0
interface. For example, point your browser to https://10.1.1.10.
TIP: For additional information, see the SMA 210/410 Quick Start Guide.
To Next Page
Loading...
Need help?
General