SN32F260 Series
32-Bit Cortex-M0 Micro-Controller
SONiX TECHNOLOGY CO., LTD Page 78 Version 1.5
01: PWM mode 2.
PWM17 is 1 when TC<MR17 during Up-counting period.
10: PWM17 is forced to 0.
11: PWM17 is forced to 1.
PWM16 output.
00: PWM mode 1.
PWM16 is 0 when TC<MR16 during Up-counting period.
01: PWM mode 2.
PWM16 is 1 when TC<MR16 during Up-counting period.
10: PWM16 is forced to 0.
11: PWM16 is forced to 1.
6.7.19 CT16Bn PWM Enable register (CT16Bn_PWMENB) (n=1)
Address Offset: 0x9C
The PWM Control register is used to configure the match outputs as PWM outputs. Each match output can be
independently set to perform either as PWM output or as match output whose function is controlled by CT16Bn_EM
register.
For each timer, a maximum of 4 single edge controlled PWM outputs can be selected on the CT16Bn_PWMCTRL[3:0]
outputs. One additional match register determines the PWM cycle length. When a match occurs in any of the other
match registers, the PWM output is set to HIGH. The timer is reset by the match register that is configured to set the
PWM cycle length. When the timer is reset to zero, all currently HIGH match outputs configured as PWM outputs are
cleared.
PWM22 enable.
0: CT16Bn_PWM22 is controlled by EM22.
1: PWM mode is enabled for CT16Bn_PWM22.
PWM21 enable.
0: CT16Bn_PWM21 is controlled by EM21.
1: PWM mode is enabled for CT16Bn_PWM21.
PWM19 enable.
0: CT16Bn_PWM19 is controlled by EM19.
1: PWM mode is enabled for CT16Bn_PWM19.
PWM18 enable.
0: CT16Bn_PWM18 is controlled by EM18.
1: PWM mode is enabled for CT16Bn_PWM18.
PWM17 enable.
0: CT16Bn_PWM17 is controlled by EM17.
1: PWM mode is enabled for CT16Bn_PWM17.
PWM16 enable.
0: CT16Bn_PWM16 is controlled by EM16.
1: PWM mode is enabled for CT16Bn_PWM16.
PWM15 enable.
0: CT16Bn_PWM15 is controlled by EM15.
1: PWM mode is enabled for CT16Bn_PWM15.
PWM14 enable.
0: CT16Bn_PWM14 is controlled by EM14.
1: PWM mode is enabled for CT16Bn_PWM14.
PWM13 enable.
0: CT16Bn_PWM13 is controlled by EM13.
1: PWM mode is enabled for CT16Bn_PWM13.
PWM12 enable.
0: CT16Bn_PWM12 is controlled by EM12.
1: PWM mode is enabled for CT16Bn_PWM12.
PWM11 enable.
0: CT16Bn_PWM11 is controlled by EM11.
1: PWM mode is enabled for CT16Bn_PWM11.