Getting started: Using the T68 as a modem
19
7.On the Port settings tab, enter the following settings:
• Data Bits: 8
• Parity: None
• Stop Bits: 1
• Flow Control: Hardware
• Term inal: leave check boxes cleared
8.On the TCP/IP tab, enter the following settings:
• Use server-assigned IP address: Select
• Use Slip: Leave cleared
• Use software compression: Leave cleared
• Use IP header compression: Leave cleared
9.On the Name Servers tab, enter the following settings:
• Use server-assigned addresses: Select, if your ISP does not ask you to enter the server
address manually.
10.Save the configuration by tapping OK and then tap Next.
11.In the Phone number box, enter
*99***1#. The number before the hash mark should be the
same as the CID for the phone’s data account.
• To check CID in the phone, scroll to:
Connect/Data comm./Data accounts. Open the account
you use for GPRS and check what CID is used for that account. If, for example, the CID is 3,
the dial string above should be
*99***3#. Tap Next.
To Next Page
Loading...
