~
Check whether the connecting cables are
damaged.
~
Check the connection to your TV (page
14)
and switch the input selector on your TV so
that the signal from the player appears on
the TV screen.
~
When playing a double-layer
BD/DVD,
the
video and audio may be momentarily
interrupted at the point where the layers
switch.
No
picture
appears
when
the
video
output
resolution
selected
in
"Output
Video
Format"
is
incorrect.
~
Press.
on the player for more than
10
seconds to reset the video output resolution
to the lowest resolution.
The
picture
does
not
fill
the
screen,
even
though
the
aspect
ratio
is
set
in
"DVD
Aspect
Ratio"
under
"Video
Settings."
~
The aspect ratio
of
the disc is fixed on your
DVD (page 42).
Video
signals
are
not
output
from
the
jacks,
other
than
from
the
HDMI
OUT
jack,
when
connecting
the
HDMI
OUT
jack
and
other
video
output
jacks
at
the
same
time.
~
Set "Output Video Format" to "Component
Video" in the "Video Settings" setup
(page 42).
The
dark
area
of
the
picture
is
too
darklthe
bright
area
is
too
bright
or
unnatural.
~
Set "Picture Quality Mode" to "Standard"
(default) (see "Adjusting pictures and
sound for videos" on page 34).
The
picture
is
not
output
correctly.
~
Check the "Output Video Format" settings
in the "Video Settings" setup (page 42).
No
SD-ROM
picture
appears.
~
Check the "BD-ROM I080124p Output"
setting
in
the "Video Settings" setup
(page 43).
See
also
"Connecting
to an
HDMI
jack"
(page
20)
when
connecting
equipment
using
the
HDMI
cable.
There
is
no
sound.
~
Check that all the connecting cables are
securely connected.
~
Check whether the connecting cables are
damaged.
~
Check the connection to your AV amplifier
(receiver) (page
19)
and switch the input
selector on your AV amplifier (receiver) so
that the audio signals
of
the player are
output from your AV amplifier (receiver).
~
The player is in scan mode.
~
If
the audio signal does not come through
the DIGITAL OUT (OPTICAL!
COAXIAL)IHDMI OUT jack, check the
audio settings (page 44).
The
sound
is
not
output
correctly.
~
Check the "Audio Output Priority" setting
in the "Audio Settings" setup (page 44).
The
sound
volume
is
low.
~
The sound volume
is
low on some BDs or
DVDs.
~
Try setting "Audio DRC" to "TV Mode" in
the "Audio Settings" setup (page 46).
~
Set "Audio A
IT"
to
"Off'
in
the "Audio
Settings" setup (page 45).
The
HD
Audio
(Dolby
Digital
Plus,
Dolby
TrueHD,
DTS-HD
High
Resolution
Audio,
and
DTS-HD
Master
Audio)
is
not
output
by
bitstream.
~
Set "BD Audio Setting" to "Direct" in the
"Audio Settings" setup (page 45).
~
Check that the connected AV amplifier
(receiver) is compatible with each
HD
Audio format.
The
interactive
audio
is
not
output.
~
Set "BD Audio Setting"
to
"Mix" in the
"Audio Settings" setup (page 45).
•
=
-
Q
...
3
I»
=:
Q
=
"continued
55
To Next Page
Loading...
