46
GB
BDV-E3200
4-446-734-81(1)
D:\NORM'S JOB\SONY HA\SO130046\BDV-
N9200_7200_5200_E3200\4446734811_GB (E3200)\090SET.fm
masterpage: Left
x [Auto Standby]
[On]: Turns on the [Auto Standby]
function. When you do not operate the
system for about 30 minutes, the
system enters standby mode
automatically.
[Off]: Off.
x [Auto Display]
[On]
: Automatically displays
information on the screen when
changing the viewing titles, picture
modes, audio signals, etc.
[Off]: Displays information only when
you press DISPLAY.
x [Screen Saver]
[On]: Turns on the screen saver
function.
[Off]: Off.
x [Software Update Notification]
[On]: Sets the system to inform you of
latest software version information
(page 41).
[Off]: Off.
x [Gracenote Settings]
[Auto]: Automatically downloads disc
information when you start or stop
playback of the disc. To download, the
system must be connected to the
network.
[Manual]: Downloads disc information
when [Video Search] or [Music Search] is
selected.
x [System Information]
You can display the system’s software
version information and the MAC
address.
x [Software License Information]
You can display the Software License
Information.
[Network Settings]
x [Internet Settings]
Connect the system to the network
beforehand. For details, see “Step 3:
Preparing for Network Connection”
(page 19).
[Wired Setup]: Select this when you
connect to a broadband router using a
LAN cable.
[Wireless Setup(built-in)]: Select this
when you use the built-in wireless LAN
of the system for wireless network
connection.
For further details, visit the following
website and check the FAQ:
http://www.sony-asia.com/section/
support
x [Network Connection Status]
Displays the current network
connection status.
x [Network Connection Diagnostics]
You can run the network diagnostic to
check if the network connection has
been made properly.
x [Connection Server Settings]
Sets whether or not to display the
connected DLNA server.
x [Renderer Set-up]
[Automatic Access Permission]: Sets
whether or not to allow automatic
access from a newly detected DLNA
controller.
[Smart Select]: Allows a Sony DLNA
controller to find the system as the
target equipment to operate by using
the infrared ray. You can set this
function to on or off.
Tip
To Next Page
Loading...
