53
GB
BDV-E3200
4-446-734-81(1)
D:\NORM'S JOB\SONY HA\SO130046\BDV-
N9200_7200_5200_E3200\4446734811_GB (E3200)\100ADD.fm
masterpage:
Right
The system does not output sound of
TV programs correctly when connected
to a set-top box.
t Set [Audio Return Channel] in [HDMI
Settings] of [System Settings] to
[Off] (page 45).
t Check the connections (page 18).
Severe hum or noise is heard.
t Move your audio equipment away
from the TV.
t Clean the disc.
The sound loses stereo effect when
you play a CD.
t Select stereo sound by pressing
AUDIO (page 34).
The sound outputs from the center
speaker only.
t Depending on the disc, the sound
may output from the center speaker
only.
No sound or only a very low-level
sound is heard from the surround
speakers.
t Check the speaker connections and
settings (pages 16, 37).
t Check the sound mode setting
(page 22).
t Depending on the source, the effect
of the surround speakers may be
less noticeable.
t A 2-channel source is being played.
Distortion occurs in the sound of a
connected equipment.
t Reduce the input level for the
connected equipment by setting
[Attenuate - AUDIO] (page 43).
A sudden loud music is heard.
t The built-in sound demonstration is
activated. Press
2 – to reduce the
volume or press x to stop the
demonstration.
Radio stations cannot be tuned in.
t Check that the antenna (aerial) is
connected securely. Adjust the
antenna (aerial).
t The signal strength of the stations is
too weak (when tuning in with
automatic tuning). Use manual
tuning.
The disc does not play.
t The region code on the BD/DVD
does not match the system.
t Moisture has condensed inside the
unit and may cause damage to the
lenses. Remove the disc and leave
the unit turned on for about half an
hour.
t The system cannot play a recorded
disc that is not correctly finalized
(page 56).
File names are not displayed correctly.
t The system can only display ISO
8859-1 compliant character
formats. Other character formats
may be displayed differently.
t Depending on the writing software
used, the input characters may be
displayed differently.
A disc does not start playing from the
beginning.
t Resume play has been selected.
Press OPTIONS and select [Play
from start], then press .
Tuner
Playback
To Next Page
Loading...
