49
GB
BDV-EF1100
4-446-737-11(1)
D:\NORM'S JOB\SONY HA\SO120045\BDV-EF1100\4446737111_GB
(CEK)\090SET.fm
masterpage: Right
Settings and Adjustments
x [Network Connection Status]
Displays the current network connection
status.
x [Network Connection
Diagnostics]
You can run the network diagnostic to
check if the network connection has been
made properly.
x [Connection Server Settings]
Sets whether or not to display the
connected DLNA server.
x [Renderer Set-up]
[Automatic Access Permission]: Sets
whether or not to allow automatic access
from a newly detected DLNA controller.
[Smart Select]: Allows a Sony DLNA
controller to find the system as the target
equipment to operate by using the infrared
ray. You can set this function to on or off.
[Renderer Name]: Displays the system’s
name as it is listed on other DLNA devices
on the network.
x [Renderer Access Control]
Sets whether or not to accept commands
from DLNA controllers.
x [PARTY Auto Start]
[On]
: Starts a PARTY or joins an existing
PARTY at the request of a networked
device compatible with the PARTY
STREAMING function.
[Off]: Off.
x [Registered Remote Devices]
Displays a list of your registered remote
devices.
To use this function, be sure to perform the
software update (page 43).
x [Remote Start]
[On]: Allows turn on the system by a
device linked via network when the system
is in standby mode.
[Off]
: The system cannot be turned on by a
device linked via network.
When you set the [Quick Start Mode] to [On], the
[Remote Start] is automatically set to [Off].
[Easy Network
Settings]
Runs [Easy Network Settings] to make the
basic network settings. Follow the on-
screen instructions.
[Resetting]
x [Reset to Factory Default Settings]
You can reset the system settings to the
factory default by selecting the group of
settings. All the settings within the group
will be reset.
x [Initialise Personal Information]
You can erase your personal information
stored in the system.
Note
Note
To Next Page
Loading...
