90
Your camcorder can automatically search for the point where the recording date
changes and starts playback from that point.
Use the Remote Commander for this operation.
Use this function to check where recording dates change or to edit the tape at each
recording date.
(1) Set the POWER switch to VCR.
(2) Press SEARCH MODE on the Remote Commander repeatedly until the DATE
SEARCH indicator appears on the screen. The indicator changes as follows:
DATE SEARCH y (no indicator)
DATE SEARCH t PHOTO SEARCH t PHOTO SCAN t (no indicator)
(3) When the current position is [b], press . to search toward [a] or press >
to search toward [c]. Your camcorder automatically starts playback at the point
where the date changes.
Each time you press . or >, your camcorder searches for the previous or
next date.
To stop searching
Press x.
Searching for a recording by date
– DATE SEARCH
[a][b][c]
JUL 5 2003JUL 4 2003 DEC 31 2003
3
2
SEARCH
MODE
DATE
01
SEARCH
DATE
00
SEARCH
To Next Page
Loading...
Need help?
General