1
Notes on the POWER lamp
• The IaOWER lamp ,hill remain lit for a while even if the unit is unplugged after use.
This is normal.
• If the I_OWER lamp does not light, set the selector to VTR (DC OUT) and disconnect
the power cord. After about one minute, reconnect the power cord.
To remove the adaptor
The adaptor is removed in the same way as the battery pack.
- CCD-TRV12frRV2ZtTRV33 only
Use the battery case (supplied) and six size AA (LR6) alkaline batteries (not supplied).
(1) Remove the battery holder from the battery case.
(2) Insert six new alkaline batteries into the battery holder, following the marking
on the holder to be sure the batteries are installed in the correct direction.
(3) Insert the battery holder with the alkaline batteries.
(4) Insert the battery case with the alkaline batteries to the battery mounting
surface of the camcorder in the same way as the battery pack (p. 7).
2 3
Battery Life
Using alkaline batteries at 77°F (25°C)
Model
While LCD open _
rec°rding_ LCDclose
While playingbackon
LCD_I
CCD-TRV12/TRV112
110 (60)
160 (90)
110
CCD-TRV22iTRV33/TRV212
105155)
150(8_)
105
_/ Approximate continuous recording time indoors is indicated outside of parentheses.
Approximate minutes when recording while you repeat recording start/stop,
zooming and turning the power on/off are indicated in parentheses. The actual
battery life may be shorter.
2_ Approximateminutes when using the LCD screen. When using both the viewfinder
and LCD screen, the battery life is shorter.
3_ Approximate continuous playback time indoors.
If the LCD BACK LIGHT switch is set to BRIGHT while the LCD screen is open, the
batte D- life is approximately 10% shorter.
20
To Next Page
Loading...
Need help?
General