CCD-TRV22_RV33_RV212
Battery pack
While LCD open 21
recording'_ LCD close
While playing back on
LCD_
NP-33(supplied) NP-98/98D! NP-80/80D NP-78
65(30) 220(110) 190(100) 175(95)
85(40) 300(170) 250 (135) 220(120)
65 220 190 100
NP_68/66H NP-C65 NP_60D
135 (70) 100 (50) 95 (50)
170 (95) 150 (80) 125 (70)
]35 100 95
'_ Approximate continuous recording time indoors is indicated outside of parentheses.
Approximate minutes when recording while you repeat recording start/stop,
zooming and turning the power on/off are indicated in parentheses. The actual
battery life may be shorter.
2_ Approximate minutes when using the LCD screen. When using both the viewfinder
and LCD screen, the battery life is shorter.
3_ Approximate continuous playback time indoors.
If the LCD BACK LIGHT switch is set to BRIGHT while the LCD screen is open, the
battery life is approximately 10% shorter.
To remove the battery pack
Slide the battery pack in the direction of the arrow.
Notes on charging the battery pack
• The POWER lamp will remain lit for a while even if the battery pack is removed and
the power cord is unplugged after charging the batter), pack. This is normal.
• If the POWER lamp does not light, set the selector to VTR (DC OUT) and disconnect
the power cord. After about one minute, reconnect the power cord and set the selector
to CtIARGE again..
• You cannot operate the camcorder using the AC power adaptor while charging the
battery pack.
m
63
¢D
m
O.
(1) Insert the top of the battery pack into the top of the batter),, mounting surface.
(2) Push the battery pack so that it attaches firmly. Make sure that you hear clicks
twice.
To Next Page
Loading...
Need help?
General