Sony CCD-TRV112 Operating Instructions (primary manual) User Manual

Symptom Cause and/or Corrective Actions
The POWER lamp does not • Set the selector to VTR (DC OUT) al_d disconnect the
light, power cord. After about one minute, try again. (p. 7}
The CHARGE lamp flashes. • See the following chart.
When the CHARGE lamp flashes
Check through the following chart.
Remove the battery pack from the AC
power adaptor. Then install the same
battery pack again.
1
When the CHARGE lamp flashes
again
Install another battery pack.
When the CHARGE lamp flashes
again
The problem is with. the AC power
adaptor.
When the CHARGE lamp does not
flash again
If the CHARGE lamp lights up and
goes out after a while, there is no
problem.*
When the CHARGE lamp does not
flash again
If the CHARGE lamp lights up and
goes out after a while, the problem is
with the battery pack installed first.
Please contact our nearest Sony dealer
in connection with the product with
the problem.
m
o-
=o
8"
Q
* If yon use a battery pack which you have just bought or which has been left unused
for a long time, the CHARGE lamp may flash at the first charging. This does not
indicate a problem. Repeat again to charge with the same battery pack.
45

Sony CCD-TRV112 Operating Instructions (primary manual) Specifications

General

Brand	Sony
Model	CCD-TRV112 Operating Instructions (primary manual)
Category	Camcorder
Language	English