Sony CDP-997 - Disassembly Procedures; Front Panel Removal Steps

CDP-997 |
SECTION 2
DISASSEMBLY
¢ In order to remove the front panel block when the power
supply does not turn on, rotate the cam with minus
screw-driver as the figure shows, and the loading part will be
moved.
Then pull out the loading part by your hand to remove the
loading panel as the figure shows. After that take out the front
panel block.
Bottom of chassis
@ Rotate the cam with a © screwdriver
in the direction of the arrow.
© Remove the loading panel
in the direction of the arrow.
@ Pull out the disc table.
Wet ae,