Sony CDP-C8ESD - Adjustments; Mechanical

CDP - C8ESD/C700/ C800
SECTION 2
ADJUSTMENTS
2-1. MECHANICAL ADJUSTMENT 2-2. BEFORE ADJUSTMENTS
Chucking Arm Height Adjustment Note: Follow the disassembly procedure in the numerical order given.
This adjustment should be parformed after the electrical adjustment
and on replacing adjusting screw, magnet, or chucking pulley. 1. Remove the case.
2. Remove the frontpanel assembly.
Procedure:
1. Set disc (YEDS-18) to the optical pick-up block. (Fig. A)
2. Adjust the bracket (press pulley) to the center of the magnet
with adjusting screw. (Fig. B) @ +K265 (2pes.)
disc table
adjusting screw
(+B3 x 25)
YEDS-18
bracket
(press pulley)
|
chucking yoke
@ front panel
assembly
@
+
BVTT3
x5
(C700)
+BV3<8 |
(C8ESD/C800)
i, © + BVTP3 x 10 (3pes.)
3. Remove the disc table assembly.
YEDS-18
magnet chucking pulley
Fig. B Fig. A
eo + BVTP3 x 10 (2pes.)
© + BVTP3 x 10 (2pcs.)
| @ rein forcement (B)
Zs © guide bracket
@ disc table assembly