28
Selecting the spectrum
analyzer
The sound signal level is displayed on a spectrum
analyzer. You can select a display for ten patterns
(A-1 to A-5 or B-1 to B-5), or the automatic
display mode where all the patterns appear.
1 Press (SOURCE) to select a source
(radio, CD, MD, or AUX).
2 Press (MENU).
3 Rotate the ./> control dial until
“SA” appears.
4 Press the –m or M+ button to
select the desired setting.
5 Press the ./> control dial.
Labelling a Demo display
— Appearing Characters
You can label a Demo display with up to 64
characters to appear when the unit is turned off.
Labels will scroll in the display with Demo set to
“on.” (The display remains lit even when the
power is off.)
1 Press (OFF).
CD/MD playback or radio reception stops
(the key illumination and display remain on).
2 Press (MENU), then rotate the
./> control dial until “Name
Input” appears.
3 Press the ./> control dial.
4 Enter the characters.
1Press (DSPL/PTY) to select the
character type.
A t a t 0 t A
2Rotate the ./> control dial to
select the desired character.
A
y
B
y
C
y
...
x
y
y
y
z
y
0
y
1
y
2
...
y
!
y
“
y
#
...
y
*
y
A
*(blank space)
3Press the M+ button after locating
the desired character.
If you press the –m button, you can
move back to the left.
4Repeat steps 1 to 3 to enter the
entire sentence.
5 Press the ./> control dial.
Tips
• Simply overwrite or enter “ ” to correct or erase a
sentence.
• To erase all sentences, press the ./> control
dial for 2 seconds after step 3.
./> control
dial
./> control
dial
To Next Page
Loading...
Need help?
General
