29
Connecting auxiliary audio
equipment
You can connect auxiliary audio equipment to
this unit with the AUX IN connector.
Selecting auxiliary equipment
Press (SOURCE) repeatedly to select
“AUX.”
Adjusting the volume level
You can adjust the volume for each connected
audio equipment.
1 Press (MENU), then rotate the
./> control dial until “AUX Level”
appears.
2 Press the ./> control dial.
3 Rotate the ./> control dial to
select the desired volume level.
The volume level is adjustable in 1 dB steps
from –6 dB to +6 dB.
4 Press the ./> control dial.
To deactivate “AUX-A” in the music
source display
1 Press (OFF).
CD/MD playback or radio reception stops
(the key illumination and display remain on).
2 Press (MENU).
3 Rotate the ./> control dial until
“AUX-A
on” appears.
4 Press the M+ button to select
“AUX-A
off.”
5 Press (MENU).
To restore the indication, select “AUX-A on.”
Additional Information
Maintenance
Fuse replacement
When replacing the fuse, be sure to use one
matching the amperage rating stated on the
original fuse. If the fuse blows, check the power
connection and replace the fuse. If the fuse blows
again after replacement, there may be an internal
malfunction. In such a case, consult your nearest
Sony dealer.
Warning
Never use a fuse with an amperage rating
exceeding the one supplied with the unit as this
could damage the unit.
Cleaning the connectors
The unit may not function properly if the
connectors between the unit and the front panel
are not clean. In order to prevent this, detach the
front panel (page 10) and clean the connectors
with a cotton swab dipped in alcohol. Do not
apply too much force. Otherwise, the connectors
may be damaged.
./> control
dial
continue to next page t
Fuse (10 A)
Main unit
Back of the front panel
To Next Page
Loading...
Need help?
General
