10
GB
5 Connect the power cord to a wall
outlet.
If the supplied adapter on the plug does not
fit your wall outlet, detach it from the plug
(only for models equipped with an adapter).
To turn on the system, press ?/1.
6 (Asian and Oceanian models only)
Set the color system to PAL or NTSC
depending on the color system of your
TV.
The color system is factory set to NTSC for
region code 3 models, and PAL for other
region code models. Each time you perform
the procedure below, the color system
changes as follows:
NTSC y PAL
1 Press DVD N (or DVD NX on the
unit) to switch the function to DVD.
2 Press x to stop playback.
3 Press ?/1 to turn off the system.
4 Press ?/1 on the unit while holding
down x on the unit.
The system turns on and the color
system is changed.
Notes
• A disturbance in the TV screen may be present for a
moment after changing the color system as described
above.
• When you play back a VIDEO CD recorded in a
different color system from the one you set to the
unit, the picture image may be distorted.
• To set the VCD color system, see page 21.
To connect optional components
See page 37.
Inserting two R6 (size AA)
batteries into the remote
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Tip
With normal use, the batteries should last for about six
months. When the remote no longer operates the
system, replace both batteries with new ones.
Attaching the speaker pads
Attach the supplied speaker pads to the bottom
of the speakers to stabilize the speakers and
prevent them from slipping.
To Next Page
Loading...
Need help?
General
