Sony CMT-DV2D - Recording with External Components; Recording Audio from Components to Tape; Recording to Digital Components

Optional Components
39
GB
1 Connect audio cords.
See “Hooking up optional components” on
page 37.
2 Start recording manually.
See “Recording on a tape manually” on
page 29.
1 Connect a digital optical cord.
See “Hooking up optional components” on
page 37.
2 Press DVD N (or DVD NX on the
unit) to switch the function to DVD.
3 Press x twice to stop playback.
4 Start recording with the connected
digital component (MD deck, etc.)
Refer to the operating instructions provided
with the connected component.
5 Press DVD N (or DVD NX on the
unit) to start playing.
Notes
• You cannot make a digital recording in the following
cases.
– Copy guarded DVDs
– DVD Dolby Digital or DTS bit stream output
– CD-Rs/CD-RWs* recorded in music CD format
• You cannot make a recording when “Dolby Digital”
or “DTS” under “AV” is set to “Bit Stream”. Set
“Dolby Digital” and “DTS” to “PCM”.
* Playback is possible on a connected digital
component.
Recording audio from a
connected component
Recording on a connected
component