Sony CMT-DV2D - System Configuration and Settings; Setting the System Clock; Selecting On-Screen Display Language

Getting Started
11
GB
Use buttons on the remote for the operation.
1 Press ?/1 to turn on the system.
2 Press CLOCK/TIMER SET.
3 Press . or > repeatedly to set the
hour.
4 Press ENTER.
5 Press . or > repeatedly to set the
minute.
6 Press ENTER.
The clock starts working.
To adjust the clock
1 Press CLOCK/TIMER SET.
2 Press . or > to select “CLOCK SET”,
then press ENTER.
3 Do the same procedures as step 3 to 6
above.
Notes
• The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
• You cannot set the clock in Power Saving Mode
(page 34).
You can change the on-screen display language.
1 Turn on your TV and select the video
input.
2 Press ?/1 to turn on the system.
3 Press DVD N (or DVD NX on the
unit) to switch the function to DVD.
4 Press x to stop playback.
5 Press DVD SETUP in stop mode.
6 Press < or , repeatedly to select
“Language”, then press ENTER.
7 Press M or m repeatedly to select
“OSD”, then press ENTER.
8 Press M or m repeatedly to select a
language from the displayed list, then
press ENTER.
9 Press DVD SETUP to turn off the Setup
Display.
Note
Pressing DVD SETUP in step 5 does not work when
using a JPEG disc. Eject the disc before making the
setting.
Setting the clock Selecting a language