EasyManuals Logo

Sony CMT-EP707 Operating Instructions (CMTEP707) User Manual

Sony CMT-EP707 Operating Instructions (CMTEP707)
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
Additional Information
21
GB
On operation
• If the system is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense on the lens inside the CD
player. Should this occur, the system will not
operate properly. Remove the CD and leave the
system turned on for about an hour until the
moisture evaporates.
When you move the system, take out any discs.
If you have any questions or problems concerning
your stereo system, please consult your nearest Sony
dealer.
Notes on CDs
Before playing, clean the CD with a cleaning cloth.
Wipe the CD from the center out.
Do not use solvents.
Do not expose the CD to direct sunlight or heat
sources.
Discs with non-standard shapes (e.g., heart, square,
star) cannot be played on this system. Attempting to
do so may damage the system. Do not use such
discs.
Note on CD-R/CD-RW playback
Discs recorded on CD-R/CD-RW drives may not be
played back because of scratches, dirt., recording
condition or the drive’s characteristics. Besides, the
discs, which are not yet finalized at the end of
recording cannot be played back.
Cleaning the cabinet
Use a soft cloth slightly moistened with mild
detergent solution.
To save a tape permanently
To prevent a tape from being accidentally recorded
over, break off the cassette tab from side A or B as
illustrated.
If you later want to reuse the tape for recording, cover
the broken tab with adhesive tape.
Break off the
cassette tab of
side A
Additional information
Precautions
On operating voltage
Before operating the system, check that the operating
voltage of your system is identical with the voltage of
your local power supply.
On safety
The system is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the system itself has been turned off.
Unplug the system from the wall outlet (mains) if it
is not to be used for an extended period of time. To
disconnect the cord (mains lead), pull it out by the
plug. Never pull the cord itself.
Should any solid object or liquid fall into the
component, unplug the stereo system and have the
component checked by qualified personnel before
operating it any further.
The AC power cord must be changed only at a
qualified service shop.
The nameplate is located on the bottom exteror.
On placement
Place the system in a location with adequate
ventilation to prevent heat build-up the system.
Do not place the system in an inclined position.
Do not place the system in locations where it is;
Extremely hot or cold
Dusty or dirty
Very humid
Vibrating
Subject to direct sunlight.
Use caution when placing the unit or speakers on
surfaces that have been specially treated (with wax,
oil, polish, etc.) as staining or discoloration of the
surface may result.
On heat buildup
Although the system heats up during operation, this
is not malfunction.
Place the system in a location with adequate
ventilation to prevent heat build-up in the system.
If you continuously use this system at a large volume,
the cabinet temperature of the top, side and bottom
rises considerably. To avoid burning yourself, do not
touch the cabinet.
To prevent a malfunction, do not cover the ventilation
hole.
continued

Other manuals for Sony CMT-EP707 Operating Instructions (CMTEP707)

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sony CMT-EP707 Operating Instructions (CMTEP707) and is the answer not in the manual?

Sony CMT-EP707 Operating Instructions (CMTEP707) Specifications

Amplifier Section IconAmplifier Section
front speakers power15W x 2
input sensitivity/impedance450mV, 47 kohm
output impedance8 ohms or more
CD Player Section IconCD Player Section
laser wavelength780nm
frequency response2Hz-20kHz (±0.5 dB)
optical digital output wavelength660nm
Tuner Section IconTuner Section
fm tuning range87.5-108.0MHz
am tuning range530-1, 710kHz
fm antenna terminals75 ohms Unbalanced
Front Speaker IconFront Speaker
speaker system2 Way Bass Reflex Type
speaker units4" Woofer, 1" Tweeter
nominal impedance4 ohms
Weights & Measures IconWeights & Measures
main unit dimensions7" x 9.6" x 13.1"
main unit weight11 lbs
front speaker dimensions6.6" x 9.6" x 7.2"
front speaker weight4.8 lbs
Power IconPower
power requirementsAC120V, 60Hz
power consumption38W
standby power consumption0.5W

Related product manuals