CD
9
GB
Programing the CD tracks
— Program Play
You can make a program of up to 25 tracks in
the order you want them to be played.
1 Press CD, then place a CD.
2 Press PLAY MODE repeatedly in stop
mode until “PROGRAM” appears in the
display.
3 Press DISC 1 – 3 to select a CD.
4 Turn ./ > clockwise or
counterclockwise (or press . or >
on the remote) until the desired track
appears in the display.
5 Press ENTER.
The track is programed.
6 To program additional tracks, repeat
steps 3 to 5.
7 Press nN.
Program Play starts.
To
Cancel Program
Play
Add a track to
the end of the
program
Erase the entire
program
Tip
The program you made remains in the system’s
memory even after it has been played back. Press CD,
then press nN to play the same program again.
Note
If you open the disc tray, the program you made will
be erased.
Do this
Press PLAY MODE until
“PROGRAM” or “SHUFFLE”
disappears from the display.
Do steps 3 to 5 with Program Play
stopped.
Press PGM CLEAR, when Program
Play is in stop mode.
Disc tray
number
Track
number
Programed
step number
To Next Page
Loading...
Need help?
Amplifier Section
Power
