Sony DAV-DZ310 - Using the sleep timer; Adjusting the Delay Between the Picture and Sound; Enjoying Multiplex Broadcast Sound (DUAL MONO)

58
GB
Using the sleep timer
You can set the system to turn off at a preset
time, so you can fall asleep listening to music.
Press SLEEP.
Each time you press SLEEP, the minutes display
(the remaining time) changes by 10 minutes.
When you set the sleep timer, “SLEEP” flashes
in the front panel display.
To check the remaining time
Press SLEEP once.
To change the remaining time
Press SLEEP repeatedly to select the desired
time.
To cancel the sleep timer
Press SLEEP repeatedly until “SLEEP OFF”
appears in the front panel display.
To set the sleep timer using the
system menu
1 Press SYSTEM MENU.
2 Press X/x to select “SLEEP,” then
press or c.
The selected item appears in the front panel
display.
3 Press X/x to select a setting, then
press .
The minutes display (the remaining time)
changes by 10 minutes.
4 Press SYSTEM MENU.
Adjusting the Delay
Between the Picture and
Sound
[A/V SYNC]
When the sound does not match the pictures on
the TV screen, you can adjust the delay between
the picture and sound.
1 Press DISPLAY.
2 Press X/x to select [A/V SYNC],
then press .
3 Press X/x to select a setting, then
press .
• [OFF]: Off.
• [ON]: You can adjust the delay between
the picture and sound.
Note
• Depending on the input stream, [A/V SYNC] may not
be effective.
Enjoying Multiplex
Broadcast Sound
(DUAL MONO)
You can enjoy multiplex broadcast sound when
the system receives or plays a Dolby Digital
multiplex broadcast signal.
Note
• To receive a Dolby Digital signal, you need to
connect a TV or other component to the unit with a
digital optical cord* (page 25). If your TV is
compatible with the Audio Return Channel function
(page 54), you can receive a Dolby Digital signal via
an HDMI cable.
* DAV-DZ610 only.
Press AUDIO repeatedly to select the audio
signal.
The selected item appears in the front panel
display.
Downloaded From TheatreSystem-Manual.com Manuals