1-6E
DCR-TRV255E/TRV260/TRV265/TRV265E
E
E
Block
Function
61
61
Detailed
Code
00
10
Symptom/State
Difficult to adjust focus
(Cannot initialize focus.)
Zoom operations fault
(Cannot initialize zoom lens.)
Self-diagnosis Code
Repaired by:
Correction
Inspect the lens block focus reset sensor (Pin qs of CN1551 of
VC-344 board) when focusing is performed when the control dial
is rotated in the focus manual mode and the focus motor drive circuit
(IC1553 of VC-344 board) when the focusing is not performed.
Inspect the lens block zoom reset sensor (Pin qg of CN1551 of
VC-344 board) when zooming is performed when the zoom switch
is operated and the zoom motor drive circuit (IC1553 of VC-344
board) when zooming is not performed.
IC4501
VC-344 BOARD (SIDE A)
154 : A
155 : B
1-6. CHANGE OF IC4501
Due to the change of IC4501 (mechanism control), there are two
types of versions A and B
The EEPROM data are different according to respective versions.
Also, the IC4501 version can be checked by a discrimination method
by the model name or by the adjusting remote commander.
Note 1: Changing the version does not make any changes in
schematic diagrams and the rest.
Note 2: Make it sure to confirm the version after replacing IC4501.
1. Discrimination method by the model name of
IC4501 (mechanism control)
2. Discrimination method by adjusting remote
commander
Version check method:
1) Select page: 3, and address: FF.
2) The version of IC4501 can be checked from the displayed data.
Data Version
01 A
02 B
Data change method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 1C, and input the data in the following table.
Note: To write in the non-volatile memory (EEPROM), press the
PAUSE button of the adjustment remote commander each
time to set the data.
3) Select page: 0, address: 01, and set data: 00.
Version
AB
Address
D0 40 42
To Next Page