Sony DHC-AZ1D - Recording on a Tape Manually; Manual Recording

Tape – Play/Tape – Recording
31
GB
To perform Synchro Recording
from a desired track
You can select the first track in Synchro
Recording.
1 After performing steps 1 to 4, press . or
> repeatedly to select the desired track
number.
2 Press z REC PAUSE/START on the unit
while the selected track number is flashing.
Recording starts.
To record a CD by specifying
track order
You can record only your favorite CD tracks
using Program Play. Between steps 3 and 4,
perform steps 2 to 5 of “Creating your own
program” (page 18).
To stop recording
Press x.
Notes
• CD Synchro Recording is not available with DVD,
VIDEO CD, MP3 audio tracks and JPEG image files.
• You cannot listen to other sources while recording.
• If the play mode is set to Repeat Play or Shuffle Play,
it automatically switches to Normal Play in step 4.
• The sound effect automatically switches to “FLAT”
in step 4.
You can record just the portions you like from a
disc (DVD, VIDEO CD, CD and MP3) or radio
program on a tape.
You can also record from connected
components (see “Hooking up optional
components” (page 42)).
Use buttons on the unit for the operation.
1 Load a recordable tape.
2 Press one of the following buttons to
select the desired source to record.
• DVD NX: To record from this
system’s CD/DVD player. Playback
starts automatically if a disc is loaded.
Press x to stop playback. To cancel
Resume Play, press x twice.
• TUNER/BAND: To record from this
system’s tuner.
• PC/TV/AUDIO IN: To record from the
optional component connected to the PC
port, AUDIO IN jack or TV IN L/R
jacks.
3 Press z REC PAUSE/START.
The tape deck stands by for recording.
“REC” flashes.
4 Press z REC PAUSE/START, then start
playing the desired source to record.
Recording starts.
To stop recording
Press x.
Notes
• You cannot listen to other sources while recording.
• If no sound is being recorded when recording from a
DVD, set “Dolby Digital” or “DTS” to “PCM” under
“AV” in the Setup Display.
• The sound effect automatically switches to “FLAT”
in step 3.
Tip
For recording from the tuner:
If noise is heard while recording from the tuner, move
the respective antenna to reduce the noise.
Recording on a tape
manually
— Manual Recording