44
GB
1 Connect audio cords.
See “Hooking up optional components”
(page 42).
2 Start recording manually.
See “Recording on a tape manually”
(page 31).
1 Connect a digital optical cord.
See “Hooking up optional components”
(page 42).
2 Press DVD (or FUNCTION + or –
repeatedly) to switch the function to
DVD.
Playback starts automatically if a disc with
auto playback function is loaded. Press x to
stop playback. To cancel Resume Play,
press x twice.
3 Start recording with the connected
digital component (MD deck, etc.).
Refer to the operating instructions provided
with the connected component.
4 Press H (or DVD NX on the unit) to
start playing.
Notes
• You cannot make a digital recording in the following
cases.
– Copy guarded DVDs
– DVD Dolby Digital or DTS bit stream output
– CD-Rs/CD-RWs recorded in music CD format
• You cannot make a recording when “Dolby Digital”
or “DTS” under “AV” is set to “Bit Stream.”
Recording audio from a
connected component
Recording on a connected
component
To Next Page
Loading...
Need help?
General
