Sony DHC-AZ1D - Listening to Audio from a Connected Component; Enjoying the 5.1 Channel Sound with the Optional Amplifier

Optional Components
43
GB
Use buttons on the unit for the operation.
1 Connect audio cords.
See “Hooking up optional components”
(page 42).
2 Press VOLUME – to turn down the
volume.
3 Press PC/TV/AUDIO IN repeatedly until
“TV” or “AUDIO IN” appears.
• TV: To listen to audio from an optional
component connected to TV IN L/R jacks.
The function switches to TV.
• AUDIO IN: To listen to audio from an
optional component connected to the
AUDIO IN jack.
The function switches to AUDIO IN.
4 Start playing the connected
component.
5 Press VOLUME + or – to adjust the
volume.
1 Connect a digital optical cord.
See “Hooking up optional components”
(page 42).
2 Connect 6 speakers to an AV amplifier
equipped with a decoder.
For the speaker placement, refer to the
operating instructions supplied with the
connected amplifier.
3 Press DISPLAY in stop mode.
The Setup Display appears.
4 Press < or , repeatedly to select
“AV,” then press ENTER.
5 Press M or m repeatedly to select
“Dolby Digital” or “DTS,” then press
ENTER.
6 Press M or m repeatedly to select “Bit
Stream,” then press ENTER.
7 Press DISPLAY to turn off the Setup
Display.
8 Switch the output to 5.1 channel Dolby
Digital sound or 5.1 channel DTS
sound.
See “Changing the sound/subtitle/angle”
(page 20).
Listening to audio from a
connected component
Enjoying the 5.1 channel
sound with the optional
amplifier