Sony DHC-FLX7D - Specifying the Speaker Parameters

14
GB
x Rear speaker position and
height
Specify the position and height of the rear
speakers. The default settings are underlined.
• R. PL. BEHIND
Select this if the rear speakers are located in
the section B.
• R. PL. SIDE
Select this if the rear speakers are located in
the section A.
• R. HGT. LOW
Select this if the rear speakers are located in
the section D.
• R. HGT. HIGH
Select this if the rear speakers are located in
the section C.
Use the remote for the operation.
1 From your listening position, press
AMP MENU.
Adjustable menus and parameters are
described below.
2 Press V or v repeatedly until “LEVEL
MENU” appears.
3 Press ENTER.
4 Press V or v repeatedly to select the
parameter.
5 Press B or b repeatedly to select the
setting you want.
6 Repeat steps 4 to 5 to set other
parameters.
7 Press ENTER.
Tips
• You can use the digipad instead of the cursor buttons
(V/v/B/b).
• You can use “SPEAKER SETUP” in the Setup
Display to specify the balance, level, and test tone
parameters (page 29).
Adjustable parameters
The default settings are in the parentheses.
x BALANCE
• FRNT L___R: (center)
Balance between the front left and right
speakers.
• REAR L___R: (center)
Balance between the rear left and right
speakers.
Range: 6 steps to the left and 6 steps to the right
(13 steps)
90
20
45
AA
BB
Position diagram
60
30
CC
DD
Height diagram
Specifying the speaker
parameters