Getting Started
15
GB
x LEVEL
• CENTER: (0 dB)
Level of the center speaker (–6 dB to +6 dB,
1 dB steps).
•REAR: (0 dB)
Level of the rear speakers (–6 dB to +6 dB,
1 dB steps).
• SUB W.: (+2 dB)
Level of the sub woofer (–6 dB to +6 dB, 1 dB
steps).
x D.COMP.
• D.COMP.: (OFF)
Dynamic range compression.
Range: OFF, 0.1 to 0.9, STD, MAX
“OFF” does not compress the dynamic range.
“0.1” to “0.9” settings allow you to compress
the dynamic range in small steps. “STD”
reproduces the sound track with the dynamic
range intended by the recording engineer.
“MAX” provides a great compression of the
dynamic range.
x TEST TONE
• TEST TONE: (OFF)
Test tone output.
Range: OFF, ON
“ON” outputs the test tone from each speaker
in sequence. Adjust the LEVEL and
BALANCE parameters so that the volume
level of the test tone from each speaker
sounds the same using the remote from your
listening position. Select “OFF” to turn off the
test tone.
Notes
• When 2.1CH/MULTI is set to “2.1CH” (page 53),
you cannot set rear speaker balance, center level, rear
level.
• Dynamic range compression is possible with Dolby
Digital sources only.
1 Turn on the system.
2 Press CLOCK/TIMER SET on the
remote.
3 Press . or > repeatedly to set the
hour.
4 Press ENTER on the remote.
5 Press . or > repeatedly to set the
minutes.
6 Press ENTER on the remote.
To adjust the clock
1 Press CLOCK/TIMER SET on the remote.
2 Press . or > repeatedly to select
“CLOCK SET?”, then press ENTER on the
remote.
3 Do the same procedures as step 3 to 6
above.
Note
The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
Setting the clock
To Next Page
Loading...
