5-4
5. REPAIR PARTS LIST
5. REPAIR PARTS LIST
DSC-M1
5-1-2. BATTERY HOLDER SECTION
Ref. No. Part No. Description Ref. No. Part No. Description
51 1-479-041-11 SWITCH BLOCK, CONTROL (PW80000)
52 2-320-830-01 SHEET, RADIATION
53 A-1088-359-A SY-114 BOARD, COMPLETE (SERVICE)(J)
53 A-1104-976-A SY-114 BOARD, COMPLETE (SERVICE)
(EXCEPT J)
54 2-320-837-01 SHEET (SY), RADIATION
55 2-320-838-01 GUARD, BT TERMINAL
56 2-515-488-21 SCREW (M1.7), LOCK ACE, P2
57 X-2024-373-1 HOLDER ASSY, BT
58 A-1081-827-A FP-036 FLEXBLE BOARD
59 1-864-627-11 FP-039 FLEXIBLE BOARD
60 1-864-628-11 FP-040 FLEXIBLE BOARD
0 BT001 1-528-999-51 BATTERY, LITHIUM SECONDARY
BT901 1-780-061-11 BATTERY TERMINAL BOARD
CAUTION :
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Note :
The components identified by
mark 0 or dotted line with mark
0 are critical for safety.
Replace only with part number
specified.
Note :
Les composants identifiés par
une marque 0 sont critiques
pour la sécurité.
Ne les remplacer que par une
pièce portant le numéro spécifié.
BT901
X
Y
A
B
SY-114
57
55
59
52
58
56
51
56
56
60
54
54
52
53
52
BT001
BT001 (Lithium battery) FP-040 flexlbe board on the mount position (See page 4-51)
SY114
PW80000
Position of attaching "54"Be sure not to protrude it from the IC.
Position of attaching "52"
X direction: Align the edge of "52" with the bottom
of the IC as shown in the left figure.
Y direction: Align the edge of "52" with the left end of the coil.
Attach 52 in such a manner that the coil
(A) and (B) are covered with 52.
Note 2:
Note 2:
Note 1:
Note1:
Ver 1.1 2005. 04
To Next Page
Loading...
