25
Using the Wireless Remote Control Function
Display of the +48V Power
Setting
(+48V)
The +48V power setting of the transmitter
is displayed.
Wireless Remote Control
Function (RF REMOTE)
This function must be set to allow the
wireless remote control function to be used
between the transmitter and receiver.
OFF
: Stops the wireless remote control
function.
ON: Starts the wireless remote control
function with the previously paired
receiver.
PAIRING: Executes a new pairing.
For details, see “Using the Wireless Remote Control
Function” on page 25.
Using the
Wireless Remote
Control Function
This receiver is equipped with a wireless
remote control function that can be used to
set the parameters (low-cut filter,
attenuation operation, power save mode,
etc.) of the transmitter through the TX1/2
menu. This function makes it easier to
operate and manage the microphone system
while in the field.
This wireless control is 2.4 GHz
IEEE802.15.4 compliant and has no effect
on the RF band of digital wireless audio.
This function is activated when pairing is
established between the transmitter and the
receiver using the RF REMOTE function.
Refer to the supplied transmitter software
compatibility table beforehand to confirm
whether the software version of the
transmitter you intend to use is suitable for
use with this receiver.
If the software version is not suitable for use
with this receiver, the wireless remote
control function may not function. A
software update may be necessary to enable
proper functioning. For details on software
updates, contact your Sony service
representative.
Pairing with a Transmitter
The transmitter that you want to control
using the wireless remote control function
is linked to the receiver via the pairing
operation.
In addition to using the following
procedure, you can also set the POWER
Note
To Next Page
Loading...
