What to do if my Sony DWTP01N/14 Transmitter does not turn on?
If your Sony Transmitter does not turn on, it could be due to the batteries being inserted backwards. Reinsert the batteries with the correct orientation. Alternatively, the batteries may be exhausted, in which case you should replace them with new ones.
Why does my Sony Transmitter have no sound?
If there is no sound from your Sony Transmitter, ensure that the channel setting on the transmitter matches the one on the receiver. Also, confirm that the setting of the encrypted transmission function is the same on both the transmitter and the receiver. Finally, the audio codec mode settings on the receiver and transmitter should match. Configure the same audio codec mode setting for both the receiver and transmitter.
What to do if interruptions in the reception occurs with Sony Transmitter?
If you are experiencing interruptions in the reception with your Sony Transmitter, first, decrease the distance to the receiver and check the reception. Also, if the RF output power setting is set to 1 mW (LOW), increase the RF output power.
Why do the batteries drain quickly on my Sony DWTP01N/14?
If the batteries in your Sony Transmitter are draining quickly, it might be because you are using manganese batteries. Try using alkaline batteries instead. Also, using the transmitter under cold conditions may affect battery life.
Why is the sound weak on my Sony Transmitter?
If the sound from your Sony Transmitter is weak, and a microphone is connected to the transmitter, set the audio input to MIC. While monitoring the audio input level meter, set the attenuator to an appropriate level. The audio input level of the transmitter may be set to LINE or the attenuation level is too high.
What to do if there is distortion in the sound of my Sony DWTP01N/14 Transmitter?
If you notice distortion in the sound from your Sony Transmitter, it may be because the attenuator is set too low for the audio input level. While monitoring the audio input level meter, set the attenuator to a level that does not produce distortion.
How to fix too much bass on Sony DWTP01N/14?
If your Sony Transmitter produces too much bass, especially if the microphone connected to the transmitter produces excessive bass because the frequency response of the transmitter extends into the low 20-Hz range, use the low-cut filter to cut the bass.
How to fix weak bass on Sony Transmitter?
If the bass is weak on your Sony Transmitter, it might be because the frequency of the low-cut filter is set too high. While monitoring the sound, decrease the low-cut filter frequency to a level that produces the proper sound quality.
What to do if wireless remote control is not possible for Sony Transmitter?
If wireless remote control is not possible with your Sony Transmitter, ensure that pairing has been established between the transmitter and receiver. If the receiver is too far from the transmitter for communication to occur, check the wireless remote control condition level and decrease the distance between the transmitter and the receiver if it is low. If the transmitter that was paired with the receiver has been paired with another receiver, carry out pairing again with the transmitter that you want to control on the receiver.
What to do if the power does not turn off on Sony DWTP01N/14 Transmitter?
If the power does not turn off on your Sony Transmitter even when the POWER switch is turned to OFF, it could be because the POWER switch is locked. Turn off the POWER switch locking function.
General| Brand | Sony |
|---|---|
| Model | DWTP01N/14 |
| Category | Transmitter |
| Language | English |
To Next Page
