Sony UWP-X5 - User Manual

Questions and Answers

S
Sara RussellAug 8, 2025
What to do if there is sound interruption or noise with my Sony Microphone system?
- K
  kingangelaAug 9, 2025
  Sound interruption or noise can occur for several reasons. It may be due to jamming radio waves; determine usable channels where the RF indications on the tuner do not appear and set both the tuner and transmitter to the same channel. If using multiple transmitters, use another channel group unaffected by jamming. Ensure the transmitter and tuner are on the same channel. If using multiple transmitters, set each to a different channel within the same channel group to avoid signal interference.
T
Terrence HarrisAug 12, 2025
How to fix distortion in the sound of my Sony Microphone system?
- J
  Jodi RobinsonAug 12, 2025
  Sound distortion can occur if the attenuation level of the transmitter is too low, causing the input level of the tuner to be extremely high. To fix this, press the – button on the transmitter in attenuation level setting mode to raise the attenuation level. Also, ensure that the transmitter and tuner are set to the same channel.
D
Diana HullAug 17, 2025
Why does my Sony Microphone system have no sound?
- W
  whitakerchristianAug 17, 2025
  If there is no sound, ensure that the channel setting on the transmitter matches the channel on the tuner. Also, verify that the transmitter is turned on, so the RF indications appear on the tuner.
C
Christopher ReedAug 21, 2025
What to do if my Sony Microphone system batteries become drained quickly?
- M
  Michaela HigginsAug 21, 2025
  If the batteries are draining quickly, replace them with new ones. Ensure you are using alkaline batteries, as manganese batteries have a significantly shorter lifespan. The UWP-X5 is being used under cold conditions.
S
Stephen MccarthyAug 26, 2025
How to fix weak sound on my Sony Microphone system?
- B
  Brittney JonesAug 26, 2025
  If the sound is weak, it could be due to a high attenuation level on the transmitter, resulting in a low output level. Decrease the attenuation level by pressing the + button on the transmitter in attenuation level setting mode. Also, check the volume on the amplifier or mixer and adjust it accordingly.
V
Veronica CollierAug 29, 2025
How to troubleshoot a Sony Microphone system that does not turn on?
- K
  Katie SmithAug 29, 2025
  If the unit does not turn on, first check that the batteries are inserted with the correct polarity. If they are, the batteries may be exhausted, so replace them with new ones. Also, the battery terminals in the transmitter may be dirty; clean the + and – terminals with a cotton swab.
C
Carol WallsSep 3, 2025
What to do if the channel cannot be changed on my Sony Microphone system?
- L
  Laura ColeSep 3, 2025
  If you cannot change the channel, restart the unit while holding down the SET button. Then, use the + and – buttons to change the channel.