Sony DXF-801 - Page 28

1-4. Replacement of Outside Holder T and Eyepiece Outer Ring
1-4. Replacement of Outside Holder T 4. Pull out two pins.
and Eyepiece Outer Ring
1. Remove the outside holder T referring to Section 1-2-
2. “Replacement of CRT/DY assembly”.
2. Push two pins to portion A by slotted screwdriver as
shown in figure.
wn
Replace outside holder T or eyepiece outer ring to new
one. Insert two pins to portion B by slotted screwdriver
Slotted screwdriver
as shown in figure.
Outside holder T
3. Remove a screw, washer and two hinge springs. Then,
remove the outside holder T and eypiece outer ring as
shown in figure arrow.
Outerside holder T
Eyepiece outer ring
Hinge springs
1-4
()
DXF-801/801CE