Page21of27
（1） Pulse
Set the pulse switch, the default value: Off.
3.10 NR
In the "noise reduction" menu click "OK" button to enter the
"noise reduction" sub-menu, you can set the corresponding parameters.
Noise reduction is in the case of very low light reduction caused
by low-light point of the picture noise to enhance the signal to noise
ratio (S / N) and image clarity, and the camera in low light conditions
catches clearly sharpness image, the quality can be guaranteed.
Set the noise reduction mode, Y / C, Y, C, off four options. Choose
noise reduction corresponds to the modes.
Select Y / C mode, you can adjust the value of brightness and
color in noise reduction between 0-15. The larger the value, the smaller
the noise is.
Select Y mode, you can adjust the Y level value decomposition.
Select C mode, you can adjust the C level value decomposition.
NR
NR MODE Y/C
Y LEVEL 0-15
C LEVEL 0-15
RETURN
To Next Page
Loading...
