33
GB
GB
Remote control does not operate.
• Check the polarity of the batteries or replace the batteries.
• Point the remote control at the remote control sensor of the display.
• Keep the remote control sensor area clear from obstacles.
• Check “Control Setting” (page 26).
• Check whether a cable is connected to the CONTROL S IN jack
(BKM-FW21 not supplied). The remote control cannot be used while
the display is controlled via a CONTROL S connection.
• Fluorescent lamps can interfere with remote control operation; try
turning off the fluorescent lamps.
Cannot connect to the network.
• Plug the cable firmly into the network terminal of the optional
adaptor (BKM-FW32/FW50/FW55, not supplied).
• Check the network settings of the PC.
• Reset to the default settings by assigning the “All Reset” setting on
the “Setup” setting menu, and then assign the appropriate settings of
the network again.
Problem Possible Remedies
To Next Page
Loading...
