41
Recording
– Basics
Checking recordings – End search/Edit search/Rec Review
If the tape has a blank portion between recorded portions
End search may not work correctly.
Edit search
You can search for the next recording start point. You cannot monitor the sound.
(1) Set the POWER switch to CAMERA.
(2) Press FN to display PAGE1.
(3) Press MENU.
(4) Select EDITSEARCH in
, then press EXEC (p. 193).
(5) Select ON, then press EXIT.
(6) Hold down 7/– or +. The recorded portion is played back.
Release 7/– or + to stop playback. If you press START/STOP, recording
begins from the point you released 7/– or +.
7/– : To go backward
+ : To go forward
Rec Review
You can check the last recorded section.
(1) Set the POWER switch to CAMERA.
(2) Press FN to display PAGE1.
(3) Press MENU.
(4) Select EDITSEARCH in
, then press EXEC (p. 193).
(5) Select ON, then press EXIT.
(6) Press 7/– momentarily.
The section you have stopped most recently will be played back for a few
seconds, and then your camcorder will return to standby.
To Next Page
Loading...
Need help?
General
